Knowing where to put jumper cables on your GMC Terrain is essential for jump-starting your vehicle in the case of a dead battery. Incorrectly connecting the jumper cables can result in damage to the vehicle’s electrical system and even pose a safety hazard. In this guide, we will walk you through the step-by-step process of where to put jumper cables on a GMC Terrain.
Locating the Battery
The first step is to locate the battery in your GMC Terrain. In the case of the GMC Terrain, the battery is typically located in the engine bay. After opening the hood, you can usually find the battery on the driver’s side of the engine compartment. It may be concealed under a plastic cover and secured with a bracket.
Identifying the Positive and Negative Terminals
Once you have located the battery, it’s important to identify the positive and negative terminals. The positive terminal is usually marked with a red cover or a “+” sign, while the negative terminal is marked with a black cover or a “-” sign. It’s crucial to correctly identify these terminals to avoid any mishaps during the jump-starting process.
Connecting the Jumper Cables
Now that you have located the battery and identified the terminals, it’s time to connect the jumper cables. Follow these steps:
- Step 1: Park the functioning vehicle close enough to the GMC Terrain so that the jumper cables can reach the batteries of both vehicles. It’s important to ensure that the vehicles do not touch each other.
- Step 2: Turn off the ignition of both vehicles and ensure that all accessories, lights, and the radio are turned off.
- Step 3: Take the red (positive) jumper cable and connect one end to the positive terminal of the dead battery on the GMC Terrain.
- Step 4: Connect the other end of the red (positive) jumper cable to the positive terminal of the functioning battery in the other vehicle.
- Step 5: Take the black (negative) jumper cable and connect one end to the negative terminal of the functioning battery in the other vehicle.
- Step 6: Finally, connect the other end of the black (negative) jumper cable to an unpainted metal surface under the hood of the GMC Terrain. This can be a bolt or a metal bracket. Do not connect it to the negative terminal of the dead battery to avoid sparks.
Starting the Vehicles
Once the jumper cables are properly connected, the next step is to start the vehicles. Follow these steps:
- Step 1: Start the engine of the functioning vehicle and let it run for a few minutes to charge the dead battery in the GMC Terrain.
- Step 2: After allowing some time for the dead battery to charge, try to start the GMC Terrain. If it starts successfully, let the engine run for a few minutes to ensure the battery is recharged.
- Step 3: Once the GMC Terrain has started, carefully disconnect the jumper cables in the reverse order of how they were connected.
Frequently Asked Questions Of Where To Put Jumper Cables On Gmc Terrain: Essential Tips
Where Should Jumper Cables Be Placed On A Gmc Terrain?
When jump-starting a GMC Terrain, locate the positive and negative terminals under the hood.
Can Jumper Cables Be Connected From The Rear Of A Gmc Terrain?
For safety and proper jump-starting, it’s recommended to connect jumper cables at the front.
What Precautions Should Be Taken When Using Jumper Cables On A Gmc Terrain?
Ensure the vehicles are in park with the ignition off and headlights and other accessories are off.
Are There Any Specific Points To Avoid Connecting Jumper Cables On A Gmc Terrain?
Avoid placing the cables near moving parts, such as the fan, or near any fuel-related parts.
Conclusion
Knowing where to put jumper cables on your GMC Terrain is a valuable skill that can get you out of a tight spot if your vehicle’s battery fails. By following the correct steps and paying attention to the polarity of the terminals, you can safely jump-start your GMC Terrain without causing any damage. It’s always a good idea to keep a set of jumper cables in your vehicle in case of emergencies.