How to Reset a Jeep Cherokee Computer: Easy Steps for Complete Reset

How to Reset a Jeep Cherokee Computer

Resetting the computer in your Jeep Cherokee can help resolve various issues, such as a check engine light, rough idling, or even improve fuel efficiency. The computer, also known as the powertrain control module (PCM), is responsible for managing the engine and transmission systems. Resetting it can clear any stored error codes and adaptive memory, providing a fresh start for the vehicle. Here’s a step-by-step guide on how to reset the computer in your Jeep Cherokee:

Step 1: Turn Off the Engine

Before resetting the computer, ensure that the engine is turned off. Park your Jeep Cherokee in a safe location and make sure the ignition is off.

Step 2: Disconnect the Battery

Locate the vehicle’s battery, usually found under the hood. Use a wrench to loosen the nut on the negative (-) terminal of the battery. Once loosened, carefully remove the negative cable from the terminal. Be cautious and avoid contact between the cable and the terminal to prevent accidental reconnection.

Step 3: Resetting the PCM

With the battery disconnected, turn on the ignition and step on the brake pedal. This will help discharge any remaining power in the system and reset the PCM. After a few minutes, turn off the ignition and release the brake pedal.

Step 4: Reconnect the Battery

Step 5: Test Drive

After resetting the computer, it’s important to drive the Jeep Cherokee to allow the computer to relearn and adapt to the driving conditions. Take your vehicle for a short test drive to ensure everything is functioning properly.

It’s important to note that resetting the computer will also clear any stored radio presets, so be prepared to reprogram them after the reset. Additionally, some models may require a specific anti-theft radio code to be re-entered, so have this information ready if needed.

When to Reset the Computer

Resetting the computer should be considered when experiencing persistent issues such as rough idling, transmission problems, or a check engine light that won’t turn off. However, if the check engine light continues to illuminate after resetting the computer, it may indicate an underlying problem that should be diagnosed by a professional mechanic.


Resetting the computer in your Jeep Cherokee can be a useful troubleshooting step for addressing various issues. By following the steps outlined above, you can effectively reset the PCM and give your vehicle a fresh start. However, always remember to exercise caution when working with the vehicle’s battery and consider seeking professional help if you’re uncomfortable performing the reset yourself.

Thank you for reading our guide on how to reset a Jeep Cherokee computer. We hope this information helps you effectively reset the PCM in your vehicle.

Leave a Comment